ООО "ПРОМЫШЛЕННАЯ АВТОМАТИЗАЦИЯ"
поставляет промышленное оборудование и электронные компоненты для автоматизации технологических процессов, зданий и сооружений, машиностроительных комплексов.

 

The BK1150 Bus Coupler connects the EtherCAT real-time Ethernet system to the modular extendable KL/KS electronic terminal blocks at fieldbus level. A unit consists of a Bus Coupler, any number of terminals from 1 to 64 (with K-bus extension: 255) and a KL9010 bus end terminal.

The Bus Coupler recognises the connected Bus Terminals and automatically allocates them into the EtherCAT process image. It is connected to the EtherCAT network via the upper interface. The lower RJ 45 socket may be used to connect further EtherCAT devices in the same strand.

The BK1150 "Compact" Bus Coupler works in an identical way to the BK1120 and supplements this series with an inexpensive DIN rail mounting coupler. The IP 20 housing of the BK1150 is around 5 mm narrower than that of the BK1120.

The Bus Terminals on the BK1150 can be parameterised via ADS by the KS2000 software; the KS2000 plug is omitted. Alternatively, the controller (PLC, IPC) can configure the Bus Terminals via PLC function blocks.

The Bus Coupler recognises the connected Bus Terminals and automatically allocates them into the EtherCAT process image. The Bus Coupler is connected to the network via the upper Ethernet interface. The lower RJ 45 socket may be used to connect further EtherCAT devices in the same strand.

In the EtherCAT network, the BK1120 Bus Coupler can be installed anywhere in the Ethernet signal transfer section (100BASE-TX) – except directly at the switch. The Bus Coupler BK9000 (for K-bus components) is suitable for installation at the switch.

  Яндекс.Метрика