ООО "ПРОМЫШЛЕННАЯ АВТОМАТИЗАЦИЯ"
поставляет промышленное оборудование и электронные компоненты для автоматизации технологических процессов, зданий и сооружений, машиностроительных комплексов.

 

ET2000 | Industrial Ethernet multi-channel probe

With the ET2000 multi-channel probe Beckhoff introduces a versatile piece of hardware for analysing any Industrial Ethernet solution. With eight ports this device enables unlimited synchronised recording of up to four independent channels at a speed of 10 or 100 Mbit/s. All real-time Ethernet standards such as EtherCAT, PROFINET, etc. and conventional office Ethernet networks are supported.

Through its compact and rugged design the ET2000 is ideal both for the local application at machines or in the laboratory. The four channels enable recording and analysis of separate networks or different points within the same network. All frames in transit – in both directions – are furnished with a high-precision time stamp in the probe hardware and copied to the Gbit uplink port. The high time stamp resolution of 1 ns enables very precise timing analysis of the connected network segments. The ET2000 probe is transparent for the connected buses. Thanks to the low cycle delay of < 1 μs the influence on the system is very small.

The device can be connected to any Gbit Ethernet interfaces on the PC side. A plug-in for the free Wireshark network monitor enables this network monitor to be used for analysing recordings and high-precision time stamps.

Technical data ET2000
Number of ports/channels 8/4
Uplink port 1 Gbit/s
Delay approx. 1 µs
Resolution time stamp 1 ns (channel 0/1)
Software interface WinPcap
Data transfer rates probe ports: 10/100 Mbit/s, uplink port: 1 Gbit/s
Hardware diagnosis 2 LEDs per channel (link/activity, 10/100 Mbit), 1 power LED
Power supply 24 (18…30) V DC, 500 mA, 3-pole terminal (+, -, PE)
Dimensions (W x H x D) approx. 100 mm x 150 mm x 40 mm
Operating temperature 0…55 °C
  Яндекс.Метрика