ООО "ПРОМЫШЛЕННАЯ АВТОМАТИЗАЦИЯ"
поставляет промышленное оборудование и электронные компоненты для автоматизации технологических процессов, зданий и сооружений, машиностроительных комплексов.

 

KM4602 | 2-channel analog output terminal 0…10 V, manual/automatic operation

 

The analog KM4602 output terminal has two potential-free analog 0 to 10 V outputs. Both are connected internally to common ground. For each channel a switch enables selection between automatic or manual mode. In automatic mode an analog value is issued depending on the process data. With the manual switch settings the value set via the potentiometer is applied to the output. For manual mode a 24 V supply is required for the Bus Coupler. The switch state can be read by the controller.

 

Technical data  
Technology single-ended
Number of outputs 2
Power supply via the K-bus
Signal voltage 0…10 V
Load min 5 kΩ (short-circuit-proof)
Output error ±0.1 % (relative to end value)
Resolution 12 bits
Conversion time ~ 1.5 ms
Electrical isolation 500 V (K-bus/signal voltage)
Current consumption power contacts – (no power contacts)
Current consumpt. K-bus typ. 75 mA
Configuration no address or configuration setting
Special features manual/automatic operation
Weight approx. 85 g
Operating/storage temperature 0…+55 °C/-25…+85 °C
Relative humidity 95 %, no condensation
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27/29
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 20/variable
Approvals CE

 

 

Further manual operating terminals  
KM1644 4-channel manual operation
KM2614 4-channel relay module 230 V AC, 16 A, potential-free change-over contact, with manual operation
KM2642, KM2652 2-channel relay module 230 V AC, 6 A, manual/automatic operation

 

  Яндекс.Метрика